Original printable pattern
Ghost in the Attic
Ghost in the Attic translates a broad wavy-hemmed ghost rising beneath two pointed attic panes into broad, separated apertures with a structurally honest field of rind between every glow shape.
- Difficulty
- Intermediate · steady hand
- Carving time
- 60–90 min
- Best shape
- tall
- Tool route
- surface score
- Participation
- teen helps · adult cuts
- Style
- storybook
Why it works
Designed around the wall that stays.
3 independent through-cut openings make a broad wavy-hemmed ghost rising beneath two pointed attic panes readable without fake ink, painted highlights, or a decorative bevel. The few secondary lines are explicitly shallow recessed scores and are not light apertures.
Exact cut order
Open the idea without losing its structure.
- 01
Choose the face and thin the wall
Match the template to the broadest stable face. Open an angled lid or rear access panel as an adult-only step, scoop with a broad spoon, and thin only the carving area to about 1 inch when practical.
- 02
Transfer without losing the bridges
Tape the Ghost in the Attic pattern smoothly, trace or pin-prick it as an adult, and mark every dashed bridge zone before removing the paper. Keep the attic floor band between the pointed panes and ghost silhouette intact.
- 03
Open the large fields
Cut the 3 labeled apertures independently, beginning with the broadest field and fully releasing each waste piece before starting the next.
- 04
Finish, press-test, and light
Round any needle-sharp corner rather than thinning the surrounding rind, then recess the labeled score line shallowly after every opening is stable. The score stays dark and never becomes a through-cut. Press gently around every bridge, clear loose pulp, and test only with the steady battery light.
Make the glow legible.
Follow the design's one-to-three-light placement plan, keeping every battery-operated LED tea light seated low on the cavity floor. The sources stay subordinate; only the through-cut apertures reveal localized warm bounce, retained rind stays dark, and no open flame is used.
Protect the finished wall.
Blot the cut surfaces dry and display the pumpkin in a cool, shaded, ventilated place. Move it out of heat and direct sun, and retire it when it becomes soft, moldy, or unstable.
Stop before forcing it.
If a bridge cracks, stop cutting and support the loose area from inside. An adult may align a small break with a short wooden pin; otherwise simplify the nearby opening or cover the area with the no-carve adaptation. Keep the attic floor band between the pointed panes and ghost silhouette intact.
Separate the materials.
Separate paper and tape, wipe and dry tools, remove the battery light, and follow local guidance for composting or food-scrap collection when the pumpkin is finished.
Complete no-carve route
Keep the composition. Change the method.
Recreate a broad wavy-hemmed ghost rising beneath two pointed attic panes with removable matte-black paper shapes, keeping the same clear spacing and leaving the pumpkin wall intact.
Open the full no-carve method →Before the first opening
Techniques this pattern depends on.
Keep looking
